Filter
Top Products
24 English
3
Specify the video options in alarm
recording.
• Rate:
Configures the recording rate for the
alarm recording.
The available options depend on the
[Alarm area] and [Resolution] settings.
•Quality:
Can change the alarm video quality
setting in the camera.
• Resolution:
Can change the alarm video resolution
setting in the camera.
4
In order to make the settings valid,
select the check box corresponding to
the camera.
5
Click [SET].
This completes the setting procedure and
the configuration is transferred to the
camera.
When you configure the alarm recording for
multiple cameras, repeat steps 1 to 5.
MEMO:
When the value for the [Alarm Duration] option is
not selected, the alarm recording for the camera
is disabled. Be sure to select the value
according to the message on the dialog.
6
Click [Close].
The [Alarm Setting] screen closes.
Note:
When recording on the camera’s memory
temporarily
• Pre-alarm video may not be recorded under
the following settings. Change one of the
settings according to the contents in the
parentheses.
Alarm area: 0.5MB (increase capacity)
Alarm Duration (Pre/Post):
10%90% (raise the ratio)
Quality: Super Fine (lower picture quality)
• During alarm recording, the alarm video
being received from the camera is displayed.
Since there is a time lag before video is
received, the displayed video will differ from
the live video.
1 Select all check box
Selecting this check box in the title row
selects all the check boxes corresponding to
the cameras listed on the [Alarm Setting]
screen.
2 [Set All] button
Executes the [SET] command for all cameras.
MEMO:
When the value for the [Alarm Duration]
option is not selected, the alarm recording for
the camera is disabled. Be sure to select the
value according to the message on the
dialog.
3 [Reload] button
Reloads the setting information to display.
MEMO:
While the setting information is being
accessed concurrently, [Reload] button can
be used to load and check the current setting
information retained on the camera.
4 [Copy] button
Copies the settings for the selected camera
and retains them in memory.
5 [Paste] button
Overrides the settings for the selected
camera with the copied contents.
6 [Paste All] button
Overrides the settings for all cameras with the
copied contents.
Other Buttons in the [Alarm Setting]
Screen
L9EBB_WA(VA-SW3050)(GB).book 24 ページ ２００６年４月２１日 金曜日 午後４時２５分