Filter
Top Products
Display reports regarding failures and changes for
timer settings.
You can check the current version of the software on
the screen.
65
Appendix
If complex adjustments are made and the settings
cannot be restored to normal, you can reset the
settings to the factory preset values.
Press
a
/
b
to select “Reset”, and then press
ENTER.
3
Press
c
/
d
to select “Yes”, and then press
ENTER.
• “Now, TV will restart automatically. OK?” displays
on the screen.
5
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Setup”.
2
Press
c
/
d
to select “Yes”, and then press
ENTER.
• “Now initialising...” displays on the screen and
blinks.
• After the reset has completed, the power shuts
off and then comes back on. The screen will have
returned to its original settings.
6
Now initialising...
After factory presetting,
TV will restart automatically
Reset
Receiver report
If you have already set the password, enter it
here.
• “Return to factory pre-settings” displays on the
screen.
4
Information
Identifi cation
Message list
When a new broadcast station is detected, the
message is updated in the “Message list” of the
“Information” menu.
Press
a
/
b
to select the desired language
listed on the screen, and then press ENTER.
Press
c
/
d
to select
“
HOME
” or “
STORE
”, and
then press
ENTER.
7
8
Digital Search
Major Analogue Channel settings are pre-set.
However if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto installation” in “Setup” section
(refer chapter “Watching TV” on manual).
Press ENTER.
• Major analogue channel settings are pre-set.
However if there are any channel(s) that you
cannot receive with the factory pre-sets, please
perform “Auto installation” in “Setup” section.
(See page 20.)
9
The TV searches for, sort and stores all the
receivable TV stations according to their settings and
the connected antenna.
• To abort the initial auto installation in progress,
press RETURN.
NOTE
• When the TV is in STORE mode, repeat steps 1 to 7 to
change to HOME mode.
Download setup
The TV automatically determines whether a new
software version is available when the TV is in standby
mode.
Selected item Description
Yes
Automatically searches for new software
updates available when the TV is in
standby mode.
No Does not search for update information.
Now
Checks if there is new software
immediately.
Downloading the software
You can select the method of update.
1 If the software is updated, the confi rmation message
“New download information has been detected.”
appears
• If the TV receives the update service while in standby
mode, a confi rmation message displays after turning on
the power.
2 Follow the screen prompts.
Selected item Description
Yes
Starts downloading immediately. It takes
approximately one hour to update. You
cannot carry out other operations while
downloading.
• Cancels the download by pressing
ENTER on the remote control unit
when “Discontinue” is displayed on the
screen during the update.
No
Starts downloading automatically several
minutes after entering standby mode.
NOTE
• The TV must remain in standby mode for download. Do not
turn off the power using POWER on the TV.
• Updating the software may take some time.
LC-40LE700X_en_h.indd 65LC-40LE700X_en_h.indd 65 7/1/09 2:21:30 PM7/1/09 2:21:30 PM