Filter
Top Products
30 TASCAM MD-CD1MKIII
Pitch control (CD only)
When playing back an audio CD, the pitch (or speed) of
the playback can be varied. Pitch can be varied –50% to
+16% for CD.
NOTE
Pitch control does not function for data CDs.
Front panel operation
1 During stop, playback or playback standby mode,
press the PITCH control to turn the Pitch Control
function on.
2 Rotate the PITCH control knob to set the pitch.
NOTE
Use the
PITCH STEP?
option in the PLAY sub-menu of
the CD menu to adjust the pitch control steps from 0.1%
to 1.0% in 0.1% increments. (Default: 0.1%)
Remote control operation
1 During stop, playback or playback standby mode,
press the PITCH button to turn the Pitch Control
function on.
2 Use the PITCH –/+ button to set the pitch.
Pitch is adjusted in 0.1% increments.
NOTE
Pitch control only functions during normal playback.
•
During recording, pitch control does not function.
When turning the pitch control on and off during
•
playback, sound output is cut for a short instant.
Single-track playback
This function enables playback of just a single track.
During stop mode, press the P. MODE button on
the remote control, and
SINGLE
lights up in the
display.
Stops playback after playback of a track has finished.
NOTE
If the Repeat function is also on, the selected track will
•
be played repeatedly.
You can also use the
•
PLAY MODE?
option in the
PLAY sub-menu of the MD and CD menus to set the
Single track playback mode.
Even when the power is turned off, the Single-track
•
playback mode settings are retained.
Program playback
This function enables playback of selected tracks in any
desired order. Up to 99 tracks can be selected from a CD,
or up to 25 tracks from an MD, for Program playback.
Programs of up to 100 discs including CD and MD can be
retained.
1 During stop mode, press the P. MODE button on
the remote control until
PROGRAM
is indicated on
the display.
The program number and total program playing
time will be shown on the character display. The
highest program number among the currently
registered programs appears on the program
number display immediately after the mode is
changed.
0p 0m 0s
Program number
Total program playing time
NOTE
You can also use the
•
PLAY MODE?
option in the
PLAY sub-menu of the MD and CD menus to set the
Program Playback mode.
The total program playing time does not appear for
•
data CDs.
Before setting up a program, press the
•
STOP (ª)
button to enter stopped status.
2 Use the number buttons on the remote control to
select each desired track for program playback,
then press the ENT/YES button.
The track number will be entered into the program.
NOTE
To set the program by front panel operation, use the
MULTI JOG dial to select the track number, then press the
dial to add the track to the program.
3 Repeat the above step 2 until the desired program
is completed.
As the program is being created, the program number
and total program playing time is revised on the
display.
To confirm program contents, press the skip buttons
during playback or playback standby.
NOTE
If the total program playing time exceeds 999 min 59 sec,
“
- - - m - - s
” is displayed.
4 When program setting is completed, press the
PLAY button to begin playback of the tracks in the
programmed order.
7 – CD and MD Playback