174 Power Tools EZConfig Utilities
MX6 Reference Guide E-EQ-MX6RG-E-ARC
Key Function Available Values
TestMode Runs the mobile device in test mode and tests the
functionality of AutoInstall. This is a diagnostic
tool. When enabled, applications stored in the
AutoInstall folder, including the radio drivers, are
not loaded during startup.
Default: 0
0=Disable
1=Enable
EZConfigKey Specifies a key that launches EZConfig Client
before Autorun starts processing the Programs
section; i.e., before Autorun starts launching
programs.
Default: 9=Tab key
Empty=You must launch
EZConfig Client to scan
bar codes from EZConfig
Editor.
Note: This section and most of its keys are locked, which means that you can change the value
but not the name or description.
Programs Section
Programs determine which programs to launch at Startup. This section has multiple child sections.
Program Sections and Launch Sequence Each section is a program to launch at startup. The
sequence of sections determines the launch sequence on the mobile device; the mobile device
reads this file consecutively. To change the launch sequence, move the section up or down in the
list; see “Working with Sections”.
Enabling and Disabling Sections If you don’t want to the application to launch at startup, you
can delete the section. However, program sections contain settings you’ll want to keep when
adding that same application back to Startup. To keep the program section in the file for future
reference, disable the program section instead of deleting it. Disabled sections appear in red. When
processing files, the mobile device behaves as though disabled sections are not there and moves on
to the next enabled section.
The following sections are enabled by default:
Section Description
Update Attempts to launch an Update.exe application from the SD (Secure Digital)
card, if one exists.
Autorun SC Attempts to process an Autorun configuration file from the SD card (if one
exists); for example, to install .CAB files from the AutoInstall folder in the SD
card. One section applies to cold boots and the other to warm boots.
Reset Initiates a warm boot after the cold boot during startup. Do NOT disable the
Reset section!
Each program section should contain the following keys:
Key Function
Program Specifies the command line to execute. This is the location of the
program’s executable. If you want a Power Tool to launch at startup,
enter the location of that tool’s .exe here.
Args Specifies the command line arguments to execute at startup.
