Fault Codes
399
016-719 Unable to process PCL print data due to insufficient print page buffer memory.
Increase the print page buffer.
016-720 The PCL print data contains an invalid command. Check the print data, and then
try again.
016-721 A print error occurred. The Auto Tray Switching setting conflicts with the Paper
Type Priority settings. When the Auto Tray Switching feature is enabled, select
an option other than [Auto Paper Off] for trays on the [Paper Type Priority]
screen.
016-722 The specified staple position is not supported. Change the staple position, and
try again.
016-723 The specified hole-punch position is not supported. Change the hole-punch
position, and try again.
016-724 The specified staple and hole-punch positions are not a valid combination.
016-725 A scanned document saved in a mailbox could not be converted to fax data
using the job flow sheet. Send the document not by using the Job Flow Sheets
service, but by using Fax service.
016-726 The printer language was not selected automatically. The probable causes are
as follows:
• PostScript data was sent to the machine, but the PostScript Kit was not
installed on the machine.
• PDF data was sent directly to the machine using the lpr command, but the
HDD was defective. Contact the Xerox Welcome Center.
• PCL data was sent to the machine, but the optional emulation kit was not
installed on the machine.
016-727 The Save to Mailbox job was cancelled, because there was no data for the job.
Check if the document is blank.
016-728 The TIFF file contains unsupported tags. Check the print data.
016-729 The TIFF file could not be printed, because the resolution of the TIFF file was
too high. Lower the resolution of the TIFF file, and try again.
016-731 The print job was interrupted. Try printing the data again.
016-732 The form specified in the emulation setting is not registered in the host
computer. Resend the form data.
016-733 The IP address after the @ character could not be obtained. Enter the e-mail
address correctly.
Or, the DNS Internet address after the @ character could not be resolved. Set
the DNS server address correctly.
016-734 Printing a simple transmission report failed. Set the [E-mail Receive Protocol] on
the sender’s end to [SMTP].
016-735 An attempt was made to print a job template while it was being updated. Wait a
while, and then try printing the template again.
016-736 A lock directory was not created.
• Check that there is space on the target disk.
• Check the access permissions.
• Delete any existing lock directory.
016-737 The lock directory was not deleted. Delete the lock directory.
Code Description and Remedy
