Filter
Top Products
24 VRX815
English
Owner’s manual
VISUAL Operations
This function is available when a VTR, etc. is con-
nected to the visual/input or visual 2 terminal.
∗ The visual 1 mode is not available when a TV tuner
is connected to the visual/input.
Switching the band
Press the [BAND] button or touch the [BAND] key.
Switching the VTR system between
NTSC and PAL
∗ This function is enabled only when the panel is open.
Switch to the VTR/DVD video mode you use.
1. Press the [ADJ] button to switch to the adjust-
ment selection display.
2. Touch the [z] key to select “VTR N/P”.
Touch the [VTR N/P] key, [NTSC] key and
[PAL] key appears in the display.
3. Touch the [NTSC] key or [PAL] key to select
“NTSC” or “PA L ”.
Adjusting the brightness and tone
of color
Notes:
• This operation is available only when the car is
stopped and the parking brake is applied.
• This function is not available when the display is
stored.
• The HUE setting can be adjusted only when the
NTSC mode is selected.
• Switch to the VTR/TV/DVD video mode you see.
1. Press the [ADJ] button to switch to the adjust-
ment selection display.
2. Touch the [MONI ADJ] key to display
[BRIGHT], [HUE] and [COLOR] key. Touch the
[BRIGHT], [HUE] and [COLOR] key to adjust
BRIGHT, HUE and COLOR.
● “BRIGHT”:
Adjust the brightness of the display.
● “HUE”:
Adjust the tone of color (red is emphasized or
green is emphasized)
● “COLOR”:
Adjust the color saturation.
3. Operate the touch key to adjust a level.
● “BRIGHT”:
[–] key or [+] key
● “HUE”:
[R] key or [G] key
● “COLOR”:
[–] key or [+] key
4. When adjustment is made, touch the [RTN]
key to return to the ADJ MENU display.
Touch the [RTN] key again to return to the
STANDARD display.
∗ To return from the adjust a level display to the
STANDARD display, press the [ADJ] button
once again.
Changing over monitor display size
∗ This function is available only when the panel is
open.
Note
• This function is not available while you are driving.
• Switch to the VTR/TV/DVD video mode you see.
1. Press the [DISP] button to change over the
monitor display size. Each time you press the
[DISP] button, the monitor display size changes
in the following order:
“NORMAL” ➜ “WIDE” ➜ “F. WIDE” ➜ “CIN-
EMA” ➜ “NORMAL”
● “NORMAL”: (normal display)
There is a black area at both right and left ends
of a display. In case of normal TV broadcast-
ing (4:3), the image can be shown without be-
ing cut or deformed.
● “WIDE”: (wide mode)
The image at right and left ends in a display
elongates horizontally.
● “F. WIDE”: (full wide mode)
The whole image elongates horizontally.
● “CINEMA”: (cinema mode)
The image at both top and bottom in a display
disappears.
Notes:
• When a normal 4:3 size image, not being a wide
one, is viewed by displaying it fully on a wide moni-
tor display in a wide mode or a full-wide mode, a
part of the peripheral image will be lacking or de-
formed. In deference to the intention of producer,
an original image can be viewed in a normal mode.
• During superimposed display, it becomes a full-wide
mode.