Filter
Top Products
34 VRX815
English
Owner’s manual
Digital Radio/DAB Operations
Switching the PTY display language
Note:
• This function is enabled only when the panel is open.
You can select one of 2 languages (English or
French) for the PTY displayed in the display.
∗ The factory default setting is “ENGLISH”.
1. Press the [ADJ] button to show the adjustment
selection display.
2. Touch the [z] key to select “PTY LAN-
GUAGE”.
Touch the desired language key to change the
setting.
3. Press the [ADJ] button. The unit returns to the
previous mode.
Volume setting of TA, emergency
broadcast (ALARM), information
and PTY
The volume for TA, ALARM, information and PTY
interrupts can be set during TA, ALARM or PTY
interrupts.
∗ The factory default setting is “15”.
During a TA, ALARM or PTY interrupt, operate
the [VOL] button upward or downward to set the
volume to the desired level (00 to 33).
∗ When the TA, ALARM, information or PTY interrupt
ends, the volume returns to the level it had before
the interrupt.
Dynamic Label Function
A dynamic label (hereinafter referred to as “DLS”)
is a text data associated with each DAB service.
This set can display DLS up to 128 characters in
a display.
∗ This function is enabled only when the panel is open.
DLS display mode
Touch the [LABEL MODE] key in the MENU dis-
play and touch the [DYNAMIC LABEL] key to
place in the DLS display mode. To cancel the DLS
mode and return to the previous display, touch the
[RTN] key. If there is a DLS data in the reception
service, DLS text is displayed in the text display-
ing area.
DLS memory
Up to six DLSs, currently being received, can be
stored. Touch the [LABEL MODE] key in the
MENU display and touch the [DYNAMIC LABEL]
key. Touch the [P.ST] key and touch and hold the
[MEMO1] to [MEMO6] key for 2 seconds or longer,
and the DLS page currently being displayed is
stored.
DLS Calling
To call the DLS stored in the DLS memory, press
the [DIRECT] button. The DLS in the DLS memory
is displayed by 16 characters (2 lines) at the inter-
vals of 5 seconds (automatic calling). To display
at shorter intervals, press the [DIRECT] button
while waiting for successive DLS character string
to be displayed, the following DLS character string
is displayed (manual calling).