Filter
Top Products
38
Installation
Installing in Japanese-Made Cars-2
■
or
Accessory I
Accessory I
Accessory J
Accessory J
When the vehicle bracket is attached as in Toyota vehicles that use a
hole in the ● position in the figure below.
Fasten Accessory J on both sides as shown in the figure below.
1
Fasten the vehicle bracket.
2
Bend the point of Accessory J, and fasten the bracket.
3
If this device can’t be fastened with screws in the 2 places on the right and left due to the vehicle bracket shape, use the
installation fastener (Accessory J) and fasten the bracket.
Using a screwdriver or pliers bend the right
and left of Accessory J so that it can be
fastened to the vehicle bracket hole.
Not use the Hard Rubber Frame
(Accessory E).
Audio Unit.etc
Screw (Provided with
the Audio Unit.etc)
Screw (Provided with
the Audio Unit.etc)
KVT-M700(K)_Eng_ver01.1 01.12.20 7:20 PM Page 38