Filter
Top Products
50
Naming Preset Channels
You can name FM/AM preset channels.
After you select the preset channel to name, execute
“Entering a Name” as described below.
You can enter up to eight characters per name.
What Characters Can Be Entered?
You can enter the following characters:
If the unit is not in “Name In” mode, execute Steps
1
and
2
in “Entering a Name,” then follow the steps below.
1
Press / repeatedly until the character
you wish to correct or erase flashes.
2
When correcting
Enter the desired character following Steps
3 and 4 in “Entering a Name” in the left
column.
When erasing
Press EDIT/NO/CLEAR on the unit or CLEAR
on the remote controller.
Notes:
• If you press and hold EDIT/NO/CLEAR for more
than two seconds, the DVD receiver returns to the pre-
vious indication without erasing characters.
• To continue entering characters, execute Step
3
in the
left column. To complete the operation, execute Step
5
.
Naming a Preset Channel
Entering a Name
1
Press EDIT/NO/CLEAR and turn
MULTI JOG until “Name In?”
appears in the display.
2
Press MULTI JOG.
3
Press DISPLAY repeatedly until
the character type you wish to
enter appears in the display.
You can select one of the following char-
acter entry modes:
•“A” for capital letters
•“a” for small letters
•“1” for numbers and symbols
1
53
2, 4
Display
The character type appears.
4
Turn MULTI JOG to select the char-
acter, then press it to enter.
Repeat this step for the next character. If
you wish to change the type of charac-
ters, repeat Step
3
, then proceed with this
step.
To cancel the entering name, press and
hold EDIT/NO/CLEAR for more than
two seconds.
5
Press YES/MODE after you enter
all the characters.
You will see the “Complete” message
that indicates the entry of characters is
completed.
Correcting and Erasing a Character
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9
_ @ ' < > # $ % & * = ; : + - / ( ) ?
! ’ ” , . (space) (insert)