Filter
Top Products
58
Setting the Clock
The ACCUCLOCK function normally uses the FM station with the strongest signal to set the clock. If the clock cannot
be set properly using that station, you can specify which FM station the ACCUCLOCK function should use. This must
be an FM station that supports RDS CT (Clock Time) information.
Tip:
You can also perform the operation by using the TIMER, ENTER, / , and MODE buttons on the remote control-
ler.
Setting ACCUCLOCK to Use a Specific Station
1
Press TIMER.
“Clock” appears on the display.
If the clock has already been set, a timer option appears instead. In this case, you’ll need to
press TIMER repeatedly until “Clock” appears.
2
Press MULTI JOG.
“*AccuClock*” or “AccuClock” appears on the display. If “Manual Adjust” appears, turn
MULTI JOG to select “*AccuClock*” or “AccuClock”.
3
Press MULTI JOG.
The display appears as shown.
4
Use / to tune into the FM station.
Tip:
Pressing YES/MODE toggles the tuning mode between “Auto Tuning” and “Manual Tuning.”
The RDS indicator appears when tuned into a station that supports RDS, as shown.
5
Press MULTI JOG.
While the clock is being set, “Wait” flashes on the display. It may take a few minutes to set the
clock. When the clock has been set, the message “Clock Adjusted” scrolls across the display,
then the day and time are displayed for a while.
Notes:
• If the clock has not been set correctly, the message “No clock signal on RDS” scrolls across
the display. Specify another FM station and try again, or set the clock manually (page 59).
• If you don’t want the clock to be updated automatically, you can turn off the ACCUCLOCK
function (page 25).
RDS