Filter
Top Products
12
13
Power supply
Connecting the power cable
1.
Attach the power cable to the unit.
Power cable
2. Connect the power cable to an AC outlet.
When using external DC power (12 V DC)
You can slide open the power cover to switch from AC input to
external DC input.
Power cover
<Note>
• If the power cover has come off or been removed, do not use
the monitor with the power supply connected to both AC input
and DC input terminals.
• Use a shielded DC cable that is not longer than 2 m. A cable
that is 2 m or longer may cause noise.
If an external DC power supply is used, be sure to check that
the rating of the external DC power supply suits the power
requirements of this unit.
When using external DC power (12 V DC), check the external
DC input terminal pin signal, and use the correct polarity. If
a +12 V power supply is accidentally connected to the GND
terminal, this could cause a fire or personal injury.
Pin number Signal
1 GND
2, 3 ―
4 +12 V
Adjusting monitor angle
Move the unit in the direction of the arrows to adjust it to a comfortable viewing position.
Forward Backward
Approx. 15 degreesApprox. 10 degrees
• The tilt stand allows you to tilt the unit approx. 10 degrees forward and approx. 15 degrees backward.
External DC input terminal
1
2 3
4