Panasonic BT-LH1850 Car Video System User Manual


 
30
Main menu (continued)
31
*
1
The settings are cancelled when the power is turned OFF.
*
2
If these settings are changed, the menu settings will also change.
*
3
The control settings do not operate during GPI operation.
*
4
Not displayed when “16:9”, “4:3” and “CENTER” are all “OFF” in the MARKER menu settings.
RESET operation
1.
Turn the rotary knob in the “SYSTEM CONFIG” menu to
select the “CALIBRATION” submenu and press the rotary
knob.
2. Turn the rotary knob to select the “RESET” submenu and
press the rotary knob.
MENUEXIT
RETURN
RETURNSEL. ENTER
[RESET]
YES
NO
3. Select “YES” and press the rotary knob.
This starts calibration.
MENUEXIT
RETURN
RETURNSEL. ENTER
[RESET]
xxxxxxxxx
xxxxxxxxx indicates that the following message with the mean-
ing listed below appears.
COMPLETE: Operation completed
4. Turn the power off and then on after performing reset op-
eration.
FUNCTION
The underlined values are factory preset setting values.
Sub menu Settings Description
FUNCTION 1 -
FUNCTION 5
HV DELAY
BLUE ONLY
GAMMA SELECT
SD ASPECT
SCAN
SUB WINDOW
WFM/VECTOR
MARKER
WHITE BALANCE
PIXEL TO PIXEL
PIXEL POSITION
FOCUS-IN-RED
LEVEL METER
CROSS HATCH
MONO
BLACK MODE
TIME CODE
CLOSED CAPTION
AUDIO MUTE
UNDEF
(Factory defaults
FUNCTION1:
MARKER
FUNCTION2: WFM/
VECTOR
FUNCTION3: PIXEL
TO PIXEL
FUNCTION4: TIME
CODE
FUNCTION5: LEVEL
METER)
Selects functions to be assigned to [FUNCTION1] - [FUNCTION5] (front panel
buttons) or the FUNCTION menu.
<HV DELAY>
*
1
Displays the image blanking period.
The display changes in the following order.
DELAY OFF → H DELAY → V DELAY → HV DELAY → DELAY OFF
<BLUE ONLY>
*
1
Cuts the red and green signals. Use this function to check phase and chroma. This
button toggles between ON and OFF.
<GAMMA SELECT>
*
2
*
3
Selects the gamma curve.
The display changes in the following order.
GAMMA STANDARD → GAMMA FILM → GAMMA STDIO/PST →
GAMMA STANDARD
<SD ASPECT>
*
2
*
3
Switches between “16:9” and “4:3.”
<SCAN>
*
2
*
3
Switches between “UNDER SCAN” and “NORMAL SCAN”.
<SUB WINDOW>
*
1
Sets the split-screen function.
The display changes in the following order.
SINGLE → FULL/PART → STILL → SINGLE
<WFM/VECTOR>
*
2
Displays waveform or vector display.
For details on the available operation items, refer to page 33.
<MARKER>
*
2
*
3
*
4
Turns the marker on and off.
For details on the available operation items, refer to page 33.
<WHITE BALANCE>
WHITE BALANCE GAIN/BIAS RGB direct adjustment can only be accessed when
VAR1 to VAR3 are selected in COLOR TEMP.
<PIXEL TO PIXEL>
Turns the PIXEL TO PIXEL function On and Off.
<PIXEL POSITION>
Positions the display of signals in PIXEL TO PIXEL mode.