Filter
Top Products
What the marks on DVDs
indicate
The marks below may be found on DVD disc
labels and packages. They indicate the type of
images and audio recorded on the disc, and
the functions you can use.
Mark Meaning
2
Indicates thenumber of audiosys-
tems.
2
Indicates thenumber of subtitlelan-
guages.
3
Indicates thenumber of viewing an-
gles.
16 : 9 LB
Indicates thepicture size (aspectratio:
screen width-to-height ratio)type.
3
4
ALL
Indicates thenumber of theregion
where playbackis possible.
When an operation is prohibited
When you are watching a DVD and attempt to
perform an operation, it may not be performed
because of the programming on the disc.
When this happens, the icon
appears on
the screen.
! The icon
may not appear with certain
discs.
Resetting the microprocessor
Pressing RESET lets you reset the micropro-
cessor to its initial settings.
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Note
After completing connections or when you want
to erase all memorized settings or returnthe unit
to its initial (factory) settings, switch your engine
ON or set the ignition switch toACC ON before
pressing RESET.
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus ( ) poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
Before You Start
En
10
Section
02