Filter
Top Products
! CUSTOM1 and CUSTOM2 are adjusted
equalizer curves.
! When FLAT is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
1 Press EQ and hold to switch to equali-
zer function.
Press EQ and hold until an equalizer curve
name appears in the display.
# To switch to SFC function, press EQ and hold
again.
2 Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
SUPER BASSPOWERFULNATURAL
VOCALFLATCUSTOM1CUSTOM2
Adjusting 3-band parametric
equalizer
For CUSTOM1 and CUSTOM2 equalizer
curves, you can adjust the front, rear and cen-
ter equalizer curves separately by selecting a
center frequency, an equalizer level and a Q
factor for each band.
! A separate CUSTOM1 curve can be cre-
ated for each source.
! A CUSTOM2 curve can be created com-
mon to all sources.
! The center speaker largely determines the
sound image and getting the balance right
isnt easy. We recommend reproducing a 2-
ch. audio (a CD for example) and getting
the balance right among the speakers ex-
cept for the center, and then reproducing a
5.1-ch. audio (Dolby Digital or DTS) and ad-
justing the center speaker output to the
balance you have already got among the
other speakers.
1 Touch A.MENU and DSP and then touch
NEXT twice.
2 Touch PARAMETRIC EQ.
3 Touch
or to select the desired
item.
Each time you touch
or selects the item
in the following order:
SP-SEL (speakers)BAND (bands)
FREQUENCY (center frequency)LEVEL
(equalizer level)Q. FACTOR (Q factor)
4 Touch
or to select the speaker to
be adjusted.
Touch
or until the desired speaker ap-
pears in the display.
REAR (rear speakers)CENTER (center speak-
er)FRONT (front speakers)
# You cannot select speakers whose size is set
at OFF.
5 Touch and then touch or to se-
lect the equalizer band to be adjusted.
Each time you touch
or selects equalizer
bands in the following order:
LOW (low)MID (mid)HIGH (high)
6 Touch
and then touch or to se-
lect the center frequency of selected band.
Touch
or until the desired frequency ap-
pears in the display.
40Hz50Hz63Hz80Hz100Hz125Hz
160Hz200Hz250Hz315Hz400Hz
500Hz630Hz800Hz1kHz1.25kHz
1.6kHz2kHz2.5kHz3.15kHz4kHz
5kHz6.3kHz8kHz10kHz12.5kHz
7 Touch
and then touch or to ad-
just the equalizer level.
Each time you touch
or increases or de-
creases the equalizer level. +06 06 is dis-
played as the level is increased or decreased.
Digital Signal Processor
En
73
Section
14
Digital Signal Processor