Filter
Top Products
1 Touch A.MENU and AUDIO and then
touch LOUDNESS.
2 Touch
to turn loudness on.
# To turn loudness off, touch .
3 Touch or to select a desired level.
Each time you touch
or selects level in
the following order:
LOW (low)MID (mid)HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
! When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1 Touch A.MENU and AUDIO and then
touch SUB WOOFER.
# When the subwoofer controller settingis
FULL, you cannot select SUB WOOFER.
2 Touch to turn subwoofer output on.
# To turn subwoofer output off, touch .
3 Touch and then touch or to se-
lect the phase of subwoofer output.
Touch
to select normal phase and
NORMAL appears in the display. Touch
to
select reverse phase and REVERSE appears in
the display.
4 Touch
and then touch or to ad-
just the output level of the subwoofer.
Each time you touch
or increases or de-
creases the level of the subwoofer. +6 6 is
displayed as the level is increased or de-
creased.
5 Touch
and then touch or to se-
lect cut-off frequency.
Each time you touch
or selects cut-off
frequencies in the following order:
50Hz80Hz125Hz
Only frequencies lower than those in the se-
lected range are outputted from the sub-
woofer.
Using nonfading output
When the nonfading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
putted through the RCA output.
1 Touch A.MENU and AUDIO and then
touch NON FADING.
# When the subwoofer controller settingis only
FULL, you can select NON FADING. (Refer to
page 83.)
2 Touch to turn non fading output on.
# To turn non fading outputoff, touch .
3 Touch or to adjust the output
level of the non fading.
Each time you touch
or increases or de-
creases the level of the non fading. +6 6 is
displayed as the level is increased or
decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
Audio Adjustments
En
62
Section
13