Filter
Top Products
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Touch A.MENU and INITIAL and then
touch DETACH WARNING.
2 Touch a to turn warning tone on.
# To turn warning tone off, touch b.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Touch A.MENU and INITIAL and then
touch AUX.
2 Touch a to turn auxiliary setting on.
# To turn auxiliary setting off, touch b.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (FULL) or subwoofer (SUB. W)
connection. If you switch the rear output set-
ting to the SUB. W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
trollers (low pass filter, phase) built-in SUB.W
or the auxiliary FULL.
! When the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you
cannot operate this function.
1 Touch A.MENU and INITIAL and then
touch REAR SPEAKER.
2 Touch
or to switch the rear out-
put setting.
Touch
to select full-range speaker and
FULL appears in the display. Touch
to select
subwoofer and SUB. W appears in the display.
# When no subwoofer is connected tothe rear
output, select FULL.
# When a subwoofer is connected to therear
output, set for subwoofer SUB. W.
# When the rear output setting is SUB.W, you
cannot change the subwoofer controller.
3 Touch or to switch the subwoofer
output or non fading output.
Touch
to select subwoofer output and
SUB.W appears in the display. Touch
to se-
lect non fading output and FULL appears in
the display.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page62)
or subwoofer output (refer to Usingsubwoofer
output on page 62) in the audio menuon.
! If you change the subwoofer controller, sub-
woofer output and nonfading output inthe
audio menu return to the factory settings.
! Both rear speaker leads output andRCA rear
output are switched simultaneously in this
setting.
Initial Settings
En
83
Section
16
Initial Settings