Filter
Top Products
Black plate (95,1)
# When a subwoofer is connected to therear
output, set for subwooferSUB. W.
# When the rear outputsetting is SUB. W, you
cannot change the subwoofer controller.
3 Touch c or d on the PREOUT setting to
switch the subwoofer output or non fading
output.
Touch c to select subwoofer output and
SUB.W appears in the display. Touch d to se-
lect non fading output and FULL appears in
the display.
Notes
! Even if you change thissetting, there is no
output unless you turnthe nonfading output
(refer to Using nonfadingoutput on page 72)
or subwoofer output (referto Using subwoofer
output on page 72)in the audio menu on.
! If you change the subwoofercontroller, sub-
woofer output and nonfading output in the
audio menu return tothe factory settings.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
% Touch FM STEP on the initial menu to
select the FM tuning step.
Touching FM STEP will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning isperformed in 50 kHz steps,sta-
tions may betuned in imprecisely. Tunein the sta-
tions with manual tuningor use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1602 kHz allowable) to 10 kHz (530 kHz
to 1640 kHz allowable).
% Touch AM STEP on the initial menu to
select the AM tuning step.
Touching AM STEP will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Changing languages for
CAUTION
Some operations on this unit are prohibited
while driving or needs to be paid a careful at-
tention when operating. In such case, a cau-
tion appears on the display. You can change
the language of the cautions at this setting.
% Touch CAUTION on the initial menu to
select your desired language.
Each time you touch CAUTION, the language
for CAUTION is switched.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is turned off, MUTE is displayed
and no audio adjustments are possible.
! The sound is attenuated, ATT is displayed
and no audio adjustments, except volume
control, are possible.
<CRB2163-B>95
Initial Setup
En
95
Section
20
Initial Setup