Pioneer AVH-P6850DVD Car Stereo System User Manual


 
Black plate (96,1)
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
% Touch TEL/GUIDE on the initial menu to
select any of the muting, attenuation or
off.
Touch TEL/GUIDE until the desired setting ap-
pears in the display.
! MUTE Muting
! ATT-20dBAttenuation (ATT-20dBhas a
stronger effect than ATT-10dB)
! ATT-10dBAttenuation
! OFF Turn thesound muting/attenuation
off
Notes
! The sound is mutedor attenuated, MUTE or
ATT are displayed and no audioadjustment is
possible.
! Operation returns to normalwhen the phone
connection or the voiceguidance is ended.
Mixing AVG-VDP1 beep and
audio sound
When connecting the AVG-VDP1 to this unit, a
beep sound is occasionally outputted from the
AVG-VDP1. To ensure the quality audio sound
from this unit, set this function to GUIDE to
properly mix the beep sound and the audio
sound.
! You can operate this function only when a
Pioneer Vehicle Dynamics Processor (AVG-
VDP1) is connected to this unit.
! When the multi-channel processor (e.g.,
DEQ-P7650/DEQ-P6600) is connected to
this unit, you cannot use this function.
! We recommend that you select GUIDE to
ensure quality sound.
% Touch VDP MIX on the initial menu to
switch the mixing of AVG-VDP1 beep.
Touching VDP MIX switches the mixing set-
tings between ALL (mixing all the time) and
GUIDE (mixing when a beep sound is out-
putted).
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
! Only when the multi-channel processor
(e.g., DEQ-P7650/DEQ-P6600) is connected
to this unit, you can operate this function.
% Touch D. ATT on the initial menu to
switch the digital attenuator setting.
Touching D. ATT switches the digital attenua-
tor settings in the following order:
HIGHLOW
Setting the TV signal
When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! This function is initially set to AUTO so that
this unit automatically adjusts the TV signal
setting.
% Touch TV SIG on the initial menu to se-
lect an appropriate TV signal.
Touching TV SIG switches TV signal settings
in the following order:
AUTOPALNTSCPAL-MSECAM
<CRB2163-B>96
Initial Setup
En
96
Section
20