Filter
Top Products
Introduction of setup
adjustments
1 Setup menu display
Shows the setup function names.
1 Touch AV MENU and then touch SETUP
to display the setup function names.
The setup function names are displayed and
operable ones are highlighted.
2 Touch ESC to return to the display of
each source.
# To return to the previous display, touch
BACK.
Setting the AV input
This unit is equipped with two video inputs,
VCR1 IN and VCR2 IN. You can connect up to
two AV components to this unit and display vi-
deos either from an AV source or S-DVD
source.
Switch the AV input setting depending on the
AV components connected to VCR1 IN and
VCR2 IN.
! Select VIDEO to watch video of a con-
nected component as AV source.
! Select S-DVD to watch video of a con-
nected DVD player as S-DVD source.
! Select CAMERA to watch a rear view cam-
era video while you are backing your vehi-
cle.
Notes
! In AV INPUT1, you can select the same set-
ting as AV INPUT2, and vice versa.
! If you have selected the same setting in
AV INPUT1 and AV INPUT2, video of the AV
component connected to VCR1 IN is output.
When AV component is
connected to AV input 1
% Touch AV INPUT1 on the setup menu to
select the AV input 1 setting.
Touch AV INPUT1 until the desired setting is
selected.
! OFF – No video component connected
! VIDEO – External video component (such
as portable video player)
! S-DVD – DVD player connected with RCA
cable
! EXT-V – External unit which can output
video
# When a DVD player is connected with an AV-
BUS cable, do not select S-DVD otherwise no pic-
ture will be displayed even if you select S-DVD as
a source.
Setup
En
100
Section
18