Filter
Top Products
About AV input 1
Depending on the unit connected to this unit,
video image may be distorted. In this case,
switch the video image selecting switch on
the underneath of the hide-away unit to the ap-
propriate position to eliminate distortion. Use
a thin standard tip screwdriver to switch the
video image selecting switch on the under-
neath of the hide-away unit.
When AV component is
connected to AV input 2
% Touch AV INPUT2 on the setup menu to
select your desired setting.
Touch AV INPUT2 until the desired setting is
selected.
! OFF – No video component connected
! VIDEO – External video component (such
as portable video player)
! S-DVD – DVD player connected with RCA
cable
! CAMERA – Rear view camera
When rear view camera is
connected to AV input 2
CAUTION
Pioneer recommends the use of a camera
which outputs mirror reversed images, other-
wise screen image may appear reversed.
You can install a rear view camera onto the AV
input 2 and display a rear view camera video.
When the gear shift is in REVERSE (R) posi-
tion, the video automatically switches to a rear
view camera video. (For more details, consult
your dealer.)
! After you set up the rear view camera set-
ting, move the gear shift in REVERSE (R)
and confirm if a rear view camera video
can be shown on the display.
! If the display should be switched to a rear
view camera video by error while you are
driving forward, change the rear view cam-
era setting.
! To end watching a rear view camera video
and return to the source display, press and
hold V.ADJUST.
1 Touch AV INPUT2 on the setup menu to
select CAMERA.
2 Touch CAMERA POLARITY on the setup
menu to select an appropriate setting for
polarity.
Each time you touch CAMERA POLARITY it
switches between the following polarity:
! BATTERY – When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
! GROUND – When the polarity of the con-
nected lead is negative while the gear shift
is in REVERSE (R) position
Setting the automatic open
function
To prevent the display from hitting the shift
lever of an automatic vehicle when it is in P
(park) position, or when you do not wish the
display to open/close automatically, you can
set the automatic open function in the manual
mode.
% Touch AUTO FLAP on the setup menu
to select the display to open/close automa-
tically or manually.
Each time you touch AUTO FLAP it switches
between the following settings:
! AUTO – The LCD panel will be opened or
closed automatically with the turning of the
ignition switch on or off
Setup
En
101
Section
18
Setup