Filter
Top Products
% Touch DETACH WARNING on the initial
menu to turn warning tone on.
# To turn warning tone off, touch
DETACH WARNING again.
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 115.
% Touch AUX1/AUX2 on the initial menu
to turn each auxiliary setting on.
# To turn auxiliary setting off, touch AUX1/
AUX2 again.
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
% Touch DIGITAL ATT on the initial menu
to switch the digital attenuator setting.
Touch DIGITAL ATT repeatedly until the de-
sired setting appears in the display.
! HIGH – High quality sound
! LOW – Minimize distortion sound
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
% Touch MUTE on the initial menu to se-
lect any of the muting, attenuation or off.
Touch MUTE until the desired setting appears
in the display.
! MUTE – Muting
! ATT –10dB – Attenuation
! ATT –20dB – Attenuation (ATT –20dB has a
stronger effect than ATT –10dB)
! OFF – Turn the sound muting/attenuation
off
Notes
! The sound is turned off, MUTE is displayed
and no audio adjustments are possible.
! The sound is attenuated, ATT is displayed and
no audio adjustments, except volume control,
are possible.
! Operation returns to normal when the phone
connection is ended.
Switching the automatic
disc playback
You can turn automatic disc playback on or off
when you insert a disc into the disc loading
slot. When this function is on, the disc will be
automatically played after it is inserted into
the disc loading slot.
Initially, this function is set to on.
Initial Settings
En
109
Section
20
Initial Settings