Filter
Top Products
Connecting and
disconnecting iPod
CAUTION
! To prevent data loss and damage to the sto-
rage device, never remove it from this naviga-
tion system while data is being transferred.
! If data loss or corruption occurs on the sto-
rage device for any reason, it is usually not
possible to recover the data. Pioneer accepts
no liability for damages, costs or expenses
arising from data loss or corruption.
Connecting your iPod
Using the USB interface cable for iPod en-
ables you to connect your iPod to the naviga-
tion system.
p For connection, USB interface cable for
iPod (CD-IU200VM) (sold separately) is re-
quired.
1 Detach the supplied USB cable after
checking that no data is being accessed.
2 Connect the USB interface cable for
iPod to both USB connector and AV input.
USB interface cable for iPod
3 Connect your iPod.
USB interface cable for iPod
p For more details about iPod compatibility
with this navigation system, refer to the in-
formation on our website.
p Connection via USB hub is not available.
Disconnecting your iPod
% Pull out the USB interface cable for iPod
after checking that no data is being ac-
cessed.
Flow from startup to
termination
1 Start the engine to boot up the system.
After a short pause, the navigation splash
screen comes on for a few seconds.
p To protect the LCD screen from damage, be
sure to touch the touch panel keys only
with your fingers. (Keep the use of other in-
struments at a minimum, and only in cases
in which the touch panel calibration is ne-
cessary.)
2 Turn off the vehicle engine to termi-
nate the system.
The navigation system is also turned off.
Basic operation
En
14
Chapter
02