Filter
Top Products
Playing DVDs on the
built-in player
8 To perform fast forward or reverse, press
and hold 1 or ¡.
• Pressing and holding 2 or 3 on the head unit
also performs the same operation.
• If you continue pressing 1 or ¡ for 5
seconds, the color of the fast reverse/fast
forward mark ( / ) changes from
white to blue. When this happens, fast
reverse/fast forward continues even if you
release 1 or ¡. To resume playback at a
desired point, press 6.
• Fast forward/fast reverse may not be possi-
ble at certain locations on some discs. If
this happens, normal playback automati-
cally resumes.
Notes
• The built-in player plays one, standard,
12-cm or 8-cm (single) DVD at a time. Do not
use an adapter when playing 8-cm DVDs.
• Do not insert anything other than a
DVD/Video CD/CD into the Disc loading slot.
• If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press EJECT to eject the disc, and check the
disc for damage before inserting the disc
again.
• If the built-in player does not operate properly,
an error message such as ERROR-11 may be
displayed. Refer to Error messages on page 89.
Specifying title (DVD mode)
Press NUMBER buttons corresponding to a
desired title number when the disc is stopped.
Title number is displayed for 8 seconds and
playback starts from the selected title.
• To select 3, press 3.
• To select 10, press 10 and 0 in order.
• To select 23, press 10, 10 and 3 in order.
Note
• You cannot select titles by using NUMBER
buttons when the remote control is set to DVH
mode.
Specifying chapter (DVD mode)
Press NUMBER buttons corresponding to a
desired chapter number during playback.
Chapter number is displayed for 8 seconds and
playback starts from the selected chapter.
• To select 3, press 3.
• To select 10, press 10 and 0 in order.
• To select 23, press 10, 10 and 3 in order.
Note
• You cannot select chapters by using NUMBER
buttons when the remote control is set to DVH
mode.
En
26
04
Section