Filter
Top Products
Playing CDs on the
built-in player
Basic operation of CD
1 Press
OPEN on the head unit to open the
front panel.
Disc loading slot appears.
• After inserting a CD, press
SOURCE to select
the built-in player.
• Pressing SOURCE on the head unit also per-
forms the same operation.
2 Insert a CD into the Disc loading slot.
When you set
AUTO PLAY :ON, playback will
automatically start. If you set AUTO PLAY :OFF,
press SOURCE to select DVD (refer to page 19).
Disc loading slot
EJECT button
• You can eject a CD by pressing EJECT on the
head unit.
• To avoid a malfunction, make sure that no
metal object comes into contact with the front
panel is open.
3 After a CD has been inserted, close the
front panel.
4 Use
VOLUME to adjust the sound level.
Press VOLUME to increase or decrease the vol-
ume level.
• Rotating VOLUME on the head unit also
increases or decreases the volume.
5 To skip back or forward to another track,
press 4 or ¢.
Track numbers are displayed for 8 seconds.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
• If the remote control is set to
DVH mode,
4 and ¢ do not operate. In this case,
press 1 or ¡ to skip to another track.
6 To perform fast forward or reverse, press
and hold 1 or ¡.
• Pressing and holding 2 or 3 on the head unit
also performs the same operation.
• If you continue pressing 1 or ¡ for 5
seconds, the color of the fast reverse/fast
forward mark ( / ) changes from
white to blue. When this happens, fast
reverse/fast forward continues even if you
release 1 or ¡. To resume playback at a
desired point, press 6.
• If you fast forward to the end of a CD, fast
forward continues from the beginning of
the disc.
• If you fast reverse to the beginning of a CD,
normal playback resumes.
Notes
• The built-in player plays one, standard,
12-cm or 8-cm (single) CD at a time. Do not
use an adapter when playing 8-cm CDs.
• Do not insert anything other than a
DVD/Video CD/CD into the Disc loading slot.
• If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press EJECT to eject the disc, and check the
disc for damage before inserting the disc
again.
• If the built-in player does not operate properly,
an error message such as ERROR-11 may be
displayed. Refer to Error messages on page 89.
En
42
06
Section