Filter
Top Products
Audio Adjustments
En
61
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off. When a sub-
woofer is connected to the rear output, first,
switch the rear output setting to subwoofer,
then turn the subwoofer output on. For more
details, see Setting the rear output and
subwoofer controller on page 75.
1 Press
A to select Sub-W1.
When the subwoofer controller setting is
S.W
Control:EXT, you cannot select Sub-W1. Press A
until Sub-W1 appears in the display.
• Pressing AUDIO on the head unit also per-
forms the same operation.
2 Press E to turn subwoofer output on.
Sub-W1 Normal appears in the display.
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
e.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
3 Press 1 or ¡ to select the phase of
subwoofer output.
Press 1 to select reverse phase and Rev.
appears in the display. Press ¡ to select nor-
mal phase and Normal appears in the display.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press A to select the
Sub-W2.
When the subwoofer output is on, you can
select the
Sub-W2. Press A until Sub-W2 80 (Hz)
appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as 50 (Hz) or 125
(Hz).
• Pressing AUDIO on the head unit also per-
forms the same operation.
2 Press 1 or ¡ to select cut-off
frequency.
Press 1 and 50 (Hz) is displayed. Press ¡
and 125 (Hz) is displayed. Only frequencies
lower than those in the selected range are out-
put from the subwoofer.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
3 Press E or e to adjust the output level
of the subwoofer.
Each press of E or e increases or decreases
the level of the subwoofer (e.g., +6 to –6).
Press E or e until you see the desired value
displayed.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
English
Español
Deutsch
Français
Italiano
Nederlands
08
Section