Filter
Top Products
Initial Settings
En
75
2 Select the desired brightness with
E or e.
• The display shows 0 – 15.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
Setting the rear output and sub-
woofer controller
This unit’s rear output (rear speaker leads out-
put) can be used for full-range speaker (Rear
SP:FULL) or subwoofer (Rear SP:S.W) connec-
tion. If you switch rear output setting to the Rear
SP:S.W, you can connect a rear speaker lead
directly to a subwoofer without using an auxil-
iary amp.
Initially, the unit is set for rear full-range speaker
connection (Rear SP:FULL).
When rear output are connected to full range
speakers (when Rear SP:FULL is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in S.W Control:INT or the
auxiliary S.W Control:EXT.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 62) or subwoofer output
(refer to page 61) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press F to select SW.
Press F repeatedly until Rear SP appears in the
display.
• Pressing FUNCTION on the head unit also
performs the same operation.
2 Change the rear output setting with E or
e.
Pressing E or e will switch between Rear SP
:FULL (full-range speaker) and Rear SP :S.W
(subwoofer) and that status will be displayed.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
Notes
• When no subwoofer is connected to the rear
output, select Rear SP:FULL.
• When a subwoofer is connected to the rear
output, set for subwoofer Rear SP:S.W.
• When the rear output setting is Rear SP:S.W,
you cannot change the subwoofer controller.
3 Change the subwoofer controller with 1
or ¡.
Pressing 1 or ¡ will switch between S.W
Control :INT and S.W Control :EXT and that
status will be displayed.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenuated
automatically when a call is made or received
using a cellular telephone connected to this
product.
1 Press
F to select TEL.
Press F repeatedly until Telephone appears in
the display.
English
Español
Deutsch
Français
Italiano
Nederlands
10
Section