Filter
Top Products
1. AV1
SCART connection.
2. RGB
TTL input (5V RGB signals) into SCART terminal.
3. AV2 (Y,Pb,Pr/ RGBHV connection)
This LCD monitor has a choice of Y, Pb, Pr or RGB H/V connections. You
can connect your DVD player to the Y, Pb, Pr terminals instead of using a
SCART lead. This can support high definition in analogue component form.
RGB H/V can be used as a PC input via the BNC terminals. Both options
support a large range of resolutions (page 24).
4. AV3
Composite (CVBS) signal input
AV3 OUT is to output the composite video signal from the VIDEO IN so that
you can connect monitors with the use of a loop through function.
5. RS232C IN/OUT
Input for external commands to control the monitor (page 19).
6. DVI-D (Digital Video Interface)
This monitor has an DVI connector. This is located at the back of the monitor
next to the phono sockets. This input will support a large range of resolutions
as shown on page 24. See page 8 for details of menu operation.
7. PC connection
This LCD monitor has a PC connector (PC-IN D-SUB). You can connect a
PC to the LCD monitor and use it as a monitor display (see page 10). Audio
can be connected via the 3.5mm PC audio in socket. This input will support a
large range of resolutions (see page 24).
8. Speaker Outputs
To output the audio signal from AV 1,2,3, PC and DVI. The speaker
impedance should be 8 ohms.
9. AV2/DVI Audio Input
10. Audio Monitor Out
The audio monitor out sockets on the rear of the set provide a fixed level
audio output for reproducing sound via your audio equipment.
11. AV2 Video Output
AV2 OUT is to output the Y, Pb, Pr or RGB H/V video signal from the AV2 IN
so that you can connect monitors with the use of a loop through function.
Installation
Runco WP-42HD Owner’s Operating Manual
2