Filter
Top Products
Operation
Runco WP-42HD Owner’s Operating Manual
13
This LCD monitor allows you to set up the following.
SETTING PROCEDURE:
1. Press and hold the green button on the remote control handset for 5 seconds.
Installation menu will appear.
2.Use the
5 or 6 button to highlight each option, use the
2
or
1
to
switch between each option.
ON Program: Select ON Program using the 6 button, select the start up position using
the
2
or
1
buttons. (Off / AV1 / RGB/ AV2/ AV3/ DVI/ PC)
Press the MENU button to exit the menu.
Max Volume: Select Max Volume using the 6 button, use the
2
or
1
buttons to
set the maximum volume required.
OSD (On-Screen Display): Select OSD using the 6 button, select ON / OFF using the
2 or1 buttons. Selecting OFF will inhibit the OSD. To reinstate OSD, press and
hold the green button on the remote control to re-enter Installation menu and select OSD
ON.
Winter Mode: This Function can be activated when the LCD monitor is used during cold
temperature conditions (approximately +38°F/+4°C or below) to maintain picture
performance.
Using the 5 or 6 button select winter mode, once highlighted you can select ON or
OFF by pressing the
2
or
1
button.
IMPORTANT: The AC cord should not be disconnected during the operation of
Winter Mode function.
When in winter mode, power consumption is higher than normal standby consumption.
This is entirely due to the operation of heating circuitry. We strongly recommend to turn
off Winter mode when the ambient temperature is above +38°F/+4°C.
RC Inhibition: You can prevent unwanted remote control operation by selecting RC
Inhibition. When selected an inhibit symbol will appear on screen when a
button is
pressed on the remote control.
➤
Installation
MENU
ON Program OFF
Max Volume
OSD ON/ OFF
Winter mode ON/ OFF
RC Inhibition ON/ OFF
Child Lock ON/ OFF
/ AV1-AV3 /RGB/ DVI/ PC
Installation
: Select
: Adjust
: Exit
Address 000-999
Baud Rate 9600 / 19200
The green button is next to the SURROUND button (refer to
page 5).
Note