Filter
Top Products
Runco WP-42HD Owner’s Operating Manualvi
Please read and retain these instructions for your safety. This unit has been engineered and manufactured to assure your
personal safety, but improper use can result in potential electric shock or fire hazards. In order not to defeat the safeguards
incorporated in this monitor, observe the following basic rules for its installation, use and servicing.
Do not allow anything to rest on the power cord. Do not locate this LCD monitor where the cord will
be damaged by people walking on it.
Do not overload wall outlets and extension cords as this can result in fire or electric shock.
A suitable socket outlet must be provided near the monitor and be easily accessible.
Do not place this LCD monitor near any heat sources such as radiators, heaters, stoves and other
heat-generating products (including amplifiers).
Do not place your LCD monitor on an unstable stand, shelf or table. Serious bodily injury and/or damage to the LCD monitor
may result if it should fall. Your sales person can recommend an approved wall mounting kit. A special wall mounting kit is
available for this model. To prevent injury, the LCD monitor must be securely attached to the wall in accordance with the
installation instructions provided with the mounting kit.
This LCD monitor should be operated only from the type of power source indicated on the monitor or as indicated in the
Operating Instructions. If you are not sure of the type of power supply, consult your sales person or your local power
company.
For added protection it is strongly recommended that this LCD monitor is supplied via an approved earth fault protection
device.
IMPORTANT: This product must be earthed
This unit is not disconnected from the mains unless the mains lead is unplugged. The installer must make sure that the
waterproof inline coupler is easily accessible.
This monitor is tested to IP56 standard rating. It is not protected against temporary or continuous immersion in liquid.
Do not use immediately after moving the LCD monitor from a low temperature to a high temperature environment, as this
causes condensation, which may result in fire, electric shock, or other hazards. Before cleaning, unplug the monitor from the
wall socket.
Do not mount near an open flame source. Open flames must never be used near this LCD monitor.
This LCD monitor should not be built in or enclosed in any way. Heat build up will reduce the life of the monitor.
This LCD monitor should have a minimum distance of 5cm away from the wall and
the monitor should have 10cm distance around the top and sides.
Always mount using recommended and substantial fixtures and fittings.
The rear finned section around the cabinet functions as a heat sink, removing heat
away from the monitor. The external surface of the cabinet (finned area) must not
be covered or the airflow restricted in anyway by enclosing the LCD monitor.
The operating temperature range of this monitor is guaranteed 0 °C ~ 40 °C (32 °F ~104 °F). It is not recommended to
install the screen in direct sunlight without adequate shading, as this will cause the temperature of the panel to rise above
the maximum specified.
Safety Precautions
10cm
10cm
10cm
5cm