Filter
Top Products
channel will be shown.
x
x
When you see the message “>>> SCAN
COMPLETE <<<”, you have completed
tuning your receiver. If no channel is found,
please refer to “TROUBLESHOOTING” in
Appendix 2.
Press the “EXIT” button several times to
leave the Main Menu.
Note: The frequencies of the “quick scan”
channels are preset in the receiver’s
database. In case that the local TV station
changes the channel frequency or a new
channel comes up, you have to scan these
channels using “MANUAL SETUP”.
AUTO SCAN (For Australia Only)
The steps required to automatically program the receiver are outlined as below:
x
x
x
x
Highlight “AUTO SCAN” and press the
“ENTER” button to start channel search.
The receiver starts scanning from channel 2
to channel 69. The status bar shows the
progress being made.
Once a digital TV channel is found, the
channel number and program name will be
shown.
When you see the message “>>> SCAN
COMPLETE <<<”, you have completed
tuning your receiver. If no channel is found,
please refer to “TROUBLESHOOTING” in
Appendix 2.
x Press the “EXIT” button several times to
leave the Main Menu.
Note: Auto scan process may take about 18
minutes to complete.
MANUAL SETUP
x On the “INSTALLATION” page, highlight
“MANUAL SETUP” and press the “ENTER”
button.
x Select channel number. Be sure you know
the channel number and its RF frequency.
You may refer to Digital TV channel table in
Appendix 1.
x Press “ź” button to highlight “Frequency”,
“Bandwidth” and “Priority” to make sure the
parameters are correct, then press “ź”
button to highlight “Start Scan” and press the
26