Filter
Top Products
FP DISPLAY SETUP
x
x
Highlight “FP DISPLAY SETUP” and press
the “ENTER” button
Use the “Ż” and “Ź” buttons to choose
“TIME” or “CHANNEL NUMBER”. This will
change the Front Panel LED display
information.
Notes:
1. TIME sets the receiver’s front panel four-digit
LED display to show current time. The
displayed current time is purely based on the
time sent by the broadcaster of the channel
you are currently viewing, which may not be
accurate.
2. When the receiver is in off-air mode,
CHANNEL NUMBER sets the receiver’s front
panel four-digit LED display to show the
channel number sent by the broadcaster.
When the receiver is in AUX mode,
CHANNEL NUMBER sets the receiver’s front
panel four-digit LED display to show “
”.
AUX IN STANDBY
x
Highlight “AUX IN STANDBY” and press the
“ENTER” button to choose to enable or
disable the AUX function when the receiver is
in standby mode.
ENABLED: When the receiver is in
standby mode, the AUX is only
applicable if MODE-Switch in the rear
panel is set to YP
B
P
R
.
DISABLED: When the receiver is in
standby mode, the AUX is not
applicable.
INFORMATION
x Highlight “INFORMATION” and press the
“ENTER” button to check hardware and
software versions.
36