Filter
Top Products
V.FORMAT (Video Format)
The “V.FORMAT” button on the remote control is used to change the video format setting among “PAL”
(for MODE-Switch being set to YP
B
P
R
only), “AUTO”, “1080i”, “720p”, and “576p”.
x
x
1
st
button press displays the current video format
Next press (within 5 seconds) sets the video format to the next format.
AUTO 1080i 720p 576pPAL
(MODE-Switch is set to YP
B
P
R
)
AUTO 1080i 720p576p
(MODE-Switch is set to RGB)
Note: For correct video format setting, please refer to System Setup Table on page 50.
A.RATIO (Aspect Ratio)
x
x
x
Press the “A.RATIO” button on the remote control to show current aspect ratio.
Within 5 seconds, pressing the “A.RATIO” button again will change the aspect ratio. Keep pressing
this button will adjust the aspect ratio among “Pillarbox”, “Letterbox” and “Crop”.
The recommended settings are shown in the table below:
If you are watching a 4:3 program If you are watching a 16:9 program
If you are using a 4:3 TV
Please use “4:3 (16:9 Crop)”. If this setting is
selected and your program is in 16:9, both sides of
the picture will be cut off to fill your 4:3 TV.
Please use “4:3 (16:9 Letterbox)”. This setting
allows you to display a 16:9 program on a 4:3 TV
screen in letterbox (with masking bars above and
below the picture).
If you are using a 16:9 TV
Please use “16:9 (4:3 Pillarbox)”. This setting
allows you to display a 4:3 program on a 16:9 TV
screen in pillarbox (with masking bars on both
sides of the picture).
Please use “16:9 (4:3 Pillarbox)”. This is the
default aspect ratio setting for Australia
.
Note: If, for purposes other than personal viewing, you display a program in an aspect ratio different
from its original setting, you may infringe on the copyrights that the program may be under.
42