Filter
Top Products
DSM 132/132RS Receiver User Guide 51
Getting Started 4
4.2 Updating the Firmware
To update the receiver firmware when a new version is released:
1. Download the upgrade files.
2. Install the FlashLoader100 utility.
3. Connect the receiver to an office computer.
4. Upgrade the firmware from the office computer, using the
upgrade files.
For full details of how to do this, refer to the Release Notes provided
with your receiver firmware.
If you have problems when you update the firmware, see Appendix A,
Troubleshooting. For further assistance, contact your local Trimble
Reseller.
Beacon FFT The receiver is looking for a beacon across the
signal spectrum.
Beacon Disabled Beacon DGPS is disabled in the receiver. You will
need to change configuration settings to enable
Beacon DGPS.
External RTCM Differential corrections are being provided by an
external source, through port A or port B.
Battery is Low This warning replaces the DGPS information when
the input voltage is low.
Table 4.5 Beacon DGPS operating mode messages (continued)
Message Description