Filter
Top Products
6 Activating Firmware Options
84 DSM 132/132RS Receiver User Guide
If any password operation fails, FlashLoader100 displays a message
that identifies the failed option. Disconnect the receiver, then
reconnect it and try again. For more information, see FlashLoader100,
page 91. If you are still unsuccessful, contact your local Trimble
Reseller for assistance.
6.1 Using an Option
This section describes how to use AgRemote to configure the receiver
for each option.
In each case, first connect to the receiver and start AgRemote.
61.1 Fast Rate Output
To configure the receiver:
1. Navigate to the Configuration / GPS Config / Position Rate
screen.
2. Press 3 to activate the cursor.
3. Press 1 or 2 to set the output rate (1, 2, 5, or 10 Hz).
4. Press 4 to save the settings.
5. Press 5 several times to return to the Home screen.
To configure the communication port:
1. Navigate to the Port A Config (or Port B Config) NMEA out
screen.
2. Press 3 to activate the cursor in the top line.
3. Press 3 to move the cursor to the second digit.
4. Press 2 until ASAP appears.
5. Press 4 to save the settings.
6. Press 5 several times to return to the Home screen.