Filter
Top Products
5 Configuring the Receiver
78 DSM 132/132RS Receiver User Guide
5. Press 1 or 2 to select the number of positions required to
determine the average current location.
6. Press 4.
The receiver begins to average positions.
7. Do one of the following:
– When all calculated positions are collected, press 4 to
accept the averaged position.
–Press 3 to cancel.
50.1 Setting the base station mode
To operate the receiver as a base station, set the base position, then
select Base Station mode:
1. Navigate to the Base Stn Config menu.
2. Press 2 until the Base Station Mode screen appears.
3. Press 3 to activate the cursor.
4. Press 1 or 2 to select ON.
5. Press 4 to save the change.
50.1 Setting the PRC mode
Use the PRC Interval screen (PseudoRange Correction) to set the
calculation interval. PseudoRange Correction is applied to the rover
receiver’s computed GPS position to correct the final position output:
1. Navigate to the Base Stn Config menu.
2. Press 2 until the PRC Interval screen appears: