Filter
Top Products
DSM 132/132RS Receiver User Guide 83
Activating Firmware Options 6
3. Press 1 or 2 to enter the first number of the password.
4. Press 3 to move to the next digit.
5. Repeat steps 3 and 4 until all numbers are entered.
6. Press 4 to save changes.
The screen displays the selected option as enabled.
If an error message appears, enter the password again. If you are still
unsuccessful, contact your local Trimble Reseller for assistance.
60.1 FlashLoader100
If you have not yet done so, install the latest version of
FlashLoader 100 on the office computer. See page 51. Use
FlashLoader100 to enter one or more passwords:
1. On the office computer, click , then select Programs /
Flashloader100.
2. In the dialog that appears, select the Update receiver with
password check box. Click
Proceed.
3. The Flash Progress dialog appears while FlashLoader100
attempts to find the receiver. When FlashLoader100 finds the
receiver, the Enter Passwords dialog appears.
If FlashLoader100 cannot find the receiver, check that the
cables are properly connected and try again.
4. In the Enter Passwords dialog, enter the 10-digit password into
the first blank line. If you have more than one option, enter each
password on a separate line. Click
OK.
The process takes a few seconds and a message appears when
completed.
5. In the dialog that appears, click
Yes to continue.
6. When the successful operation message appears, click
OK.
The option is successfully installed.