Filter
Top Products
DSM 132/132RS Receiver User Guide 61
Configuring the Receiver 5
To select the NMEA messages for output:
1. From the Port A Config menu, press 2 until the NMEA1
screen appears:
2. Press 3 to activate the cursor on the first NMEA message
type.
3. Press 1 or 2 until the NMEA message type appears in upper
case.
4. Press 3 to select the next message type.
5. Repeat steps 4 and 5 until all the message types that you want to
output appear in upper-case.
6. Press 4 to save the changes.
7. Repeat this operation as required in the other NMEA screens.
For detailed information about the content and structure of NMEA
messages, see Appendix C, NMEA-0183 Messages.
Port output rate
Use the Message Rate screen to vary the NMEA and TSIP output rate.
The default setting is 01 (1 Hz, or 1 position per second).
You can select faster output rates, such as 2, 5, or 10 positions per
second.
Note – Select ASAP if you want the output rate to be the same as the
output rate selected on the Position Rate screen under the GPS Config
menu.
åæ NMEA1 GGA gll
grs GSA gst gsv