Filter
Top Products
DSM 132/132RS Receiver User Guide 57
Configuring the Receiver 5
Use the Clear BB RAM screen to remove all configuration settings in
the receiver memory (RAM) and return the receiver to its factory
default configuration settings:
To delete battery-backed memory:
1. Navigate to the Clear BB RAM screen:
2. Press 3 to activate the cursor.
3. Press 1 or 2 to select Yes.
4. Press 4 to clear the configuration settings.
5.1 Configuring the Communication Ports
The DSM 132 receiver has two serial ports. The receiver can
communicate with two devices simultaneously through these ports. To
do this, it uses the standard power/data cable (PN 30945).
Configure the communication ports to ensure that the receiver outputs
the correct GPS position data type, for the hardware device or
software program that is connected to the receiver.
Note – As both ports are configured identically, this section describes
only Port A.
To display the Port A Config menu:
1. From the Home screen, press 3 until the Configuration menu
appears.
2. Press 2 to display the Guidance Config menu.
3. Press 3 until the Port A Config menu appears:
4. Press 2 to move through the screens as required.
Port A Config
Press v to Enter