Installation Planning Guide 8-1
8. Installation
This chapter describes the activities performed by you and Xerox
personnel during the installation of the Xerox DocuPrint 100/115/
135/155/180 EPS hardware and software components. Before
installation can begin, you must complete the tasks described in
the “Preparing for installation” chapter of this guide.
Installation process
Xerox personnel are responsible for the physical installation of
the printing system hardware components and the software.
NOTE: For customers outside the United States, contact your
local Xerox operating company for your specific installation
process.
The installation process can take one or several days to
complete. Equipment, software kits, and documentation kits may
arrive in one day, or over the course of several days. When all of
the necessary items are in place, Xerox personnel will complete
the installation of the printer components.
In the United States, the steps in the installation process typically
occur in the following order:
1. Xerox personnel install all printer hardware and connects the
controller to your site’s network through the Ethernet
connector you supply. This process takes approximately four
hours if all the necessary network and electrical connectors
are in place.
2. Xerox personnel load software on the controller
(approximately 1.5 hours).
3. Xerox personnel download Xerox client software, if
applicable, on one client workstation to validate the
installation (15 minutes). Software is downloaded on another
client workstation as part of training conducted by your
systems analyst. All other client software installations are
your responsibility.
