Supplies
Installation Planning Guide A-13
Other supplies
This section describes the supplies other than paper that are
necessary for installation and afterward. Your sales
representative will help you place your initial supply order.
Dry ink
Dry ink (also called toner) is the black powder that forms the
image on the printed page. There are three cartridges of dry ink
in each carton. You should keep at least one extra cartridge on
hand at all times. The disposable cartridges are easily changed
with no mess. The consumption rate of Xerox dry ink is
approximately one cartridge per 60,000 pages. Use only dry ink
that is specified for use in the printer, as described in the
consumable supplies table.
MICR dry ink MICR dry ink is the magnetic black powder which forms the
image on the printed MICR document. There are three
cartridges of MICR dry ink in each carton. The consumption rate
of Xerox MICR dry ink is approximately one cartridge per 60,000
pages. Use only MICR dry ink in your MICR printer.
The dry ink that is used with the DP 100/115/135/155/180 MICR
EPS is designed for MICR printing and does not function well
when used in non-MICR systems. The same procedure used for
non-MICR printing systems is used to add the dry ink to the 96/
4635/180 MICR printer.
NOTE: Dry ink (toner) yields are based on 7% area coverage.
Your yield may vary, depending on coverage.
CAUTION
Use only MICR dry ink in the DP 100/115/135/155/180 MICR
EPS printers. Do not use standard dry ink. MICR dry ink cannot
be reused.
