A SERVICE OF

logo

Open as PDF
next previous
Controller requirements and specifications
Installation Planning Guide 5-7
Figure 5-3. Sun Blade 2500 fan and vent locations to keep
clear
1. Vents in front of processor
2. Vents in back of processor
Do not:
• Place the monitor and processor on a desk or table top.
• Do not place the monitor on top of the processor.
• Do not allow any piece of equipment to blow warm air into the
air intake vents of the processor.
• Do not place the processor on its side, or in any other
position but the upright, vertical position achieved by using
the controller stand.
• Do not place the processor or monitor on top of the printer.