Printer requirements and specifications
6-16 Installation Planning Guide
Before installation, you must consider the following:
• Clearance space requirements where you intend to install the
printer
• Recommended cable lengths and locations (refer to the
“System connections” chapter of this guide for more
information)
• Delivery access requirements
• Floor leveling
Clearance space requirements
The printer must be installed in a fixed location that provides the
following clearance space:
• 36 inches / 91.4 cm on all sides of each component
• 78 inches / 198 cm of vertical clearance throughout the entire
area
• 24 inches / 61 cm of exclusive operator area in front of each
component
NOTE: There must be a total of 50 inches / 126.9 cm of
clearance space in front of the printer.
Shared space between components
It is best to provide the full amount of clearance space around
the hardware components. Your environment may require you to
use shared space between components such as between the
printer and the controller or between the printer and another
Xerox printing system. You can share the 36-inch / 91.4 cm
clearance space around each component, as long as you follow
these rules:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch / 91.4 cm general
service clearance areas, but they may not share the 24-inch /
61 cm operator area in front of each component.
• There must be 78 inches / 198 cm of vertical clearance
throughout the entire area.
