Filter
Top Products
64-EN
Installation
The main unit must be mounted within 30 degrees of the
horizontal plane, back to front.
1
Remove the mounting sleeve from the main unit
(Refer to
“Removal” on page 64). Slide the mounting
sleeve into the dashboard and fix it with the metal
shackles.
2
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the IVE-W530BT and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (*
1
) already attached
to the vehicle’s chassis. Connect all the leads of the
IVE-W530BT according to details described in the
CONNECTIONS section.
3
Slide the IVE-W530BT into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
Heat Sink
Caution
Do not block the unit’s fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Rear of the Unit
Rear of the unit
Less than 30°
Mounting Sleeve (Included)
Dashboard
This unit
Rubber Cap (Included)
Bracket key
Hex Bolt
(Included)
Face Plate (Included)
• For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
*
2
*
1
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
Hex Nut (M5)
Screw
Bolt Stud
This unit
Bracket keys
(Included)