Eclipse - Fujitsu Ten AVX5000 Car Video System User Manual


 
How to use the remote control
165
I
II
III
IV
V
VI
VII
VIII
IX
X
XI
XII
XIII
XIV
XV
XVI
XVII
XVIII
XIX
Before using remote control
Be sure to properly store the remote control when not in use. An improperly
stored remote control could shift during braking or cornering and interfere with
driving operation (for example, by becoming lodged under the brake pedal) and
cause an accident.
Do not expose the remote control to extreme heat or direct sunlight, especially
when it is in the vehicle. Doing so could cause a fire.
Precautions when using the remote control
Be careful when handling the remote control, especially because it is small and
light. Dropping or striking it may damage it, wear out the battery or cause a
malfunction.
Keep the remote control free of moisture, dust and water. Do not subject it to
shock.
Do not place the remote control unit where it will get hot, such as on the
dashboard or near a heater vent. Allowing the remote control unit to overheat
may warp its case or cause other problems.
Do not operate the remote control unit while driving because doing so could
cause an accident.
When using the remote control, point it directly at the remote control light
receptor.
The light receptor may not operate correctly if it is exposed to bright light such as
direct sunlight.
Remove the batteries from the remote control unit whenever it is not to be used
for a long time.
Store the remote control away from direct sunlight, extreme heat, and high
pressure. Exposure to these elements could result in warping of the casing,
battery rupture, or battery leakage.
Cleaning the remote control
Use a dry cloth to keep the unit clean. If the remote control unit gets extremely
dirty, clean it with a cloth moistened in a diluted liquid detergent. Do not use
alcohol or thinner; these compounds may damage the finish.
In no event should benzine or thinner be used. These substances will damage
the case or finish.