Fujitsu AVN2454 Car Video System User Manual


 
144
For reference
1. Facts to keep in mind when operating
2 preferred roads have
been set. Perform
operation again after
deleting them.
You attempted to set 3 or
more transit road
indications when
changing the route.
Up to 2 transit roads can be
indicated.
Delete unnecessary transit
roads before adding a new one.
No roads possible for
guidance nearby.
Perform operation
again after moving.
There are no roads
available to serve as
transit roads when
indicating one for a route
change.
Move the map and indicate a
transit road among the roads in
the vicinity.
Message Cause Remedy
Unable to save
additional points.
Please delete some
points.
Unable to search for
new route.
Previous route will be
displayed.
You attempted to set
more than 5 destinations.
A new route could not be
found when reinitiating a
route search.
Up to 5 destinations can be set.
Delete unnecessary destinations
and proceed with adding new
ones. (See P79)
Route guidance will proceed
using the present route.
(Drive referring to the route
guidance.)
No corresponding POI
nearby.
There is no corresponding
POI found nearby for the
POI search in the vicinity.
Search for the POI in another
area.
No corresponding POI
on route.
There is no corresponding
POI found nearby for the
POI search along the route.
Search for the POI in another
area.
Position cannot be
specified in this scale.
Switching to more
detailed map.
You attempted to set/register a
destination/memory point on a
map with a reduction scale of
more than 0.5 miles.
Set/register a destination/memory
point on a more detailed map (with
a reduction scale of less than 0.5
miles).
Destination is nearby.
Please check the map.
You attempted to set the
destination in a nearby
location.
The destination is nearby. Refer
to the map and continue driving.
The destination is
surrounded by the
water.
Change destination?
There is a river or other
body of water between
the destination and the
nearest road.
Touch , move the map
and set a destination near the
road. Touch to set the
destination on the position
displayed.
No
Yes