Filter
Top Products
22
Menu Configuration (cont.)
SCOPE SETTING
*1
Configure the settings for the wave form monitor and vector scope.
Item Content Setting value
GAIN
Adjust the input gain level. –10 – +10
SIZE
*2
*3
Set the window size. NORMAL, LARGE
POSITION
*2
Select the window position. 1 (Lower right), 2 (Lower left)
3 (Upper left), 4 (Upper right)
TRANSPARENT
*3
Make the background of the window translucent. ON
OFF
ON
OFF
:
:
Translucent
Normal
AUTO OFF
Set the function to turn off the window automatically 15 minutes after displayed. ON, OFF
WAVE DISPLAY
Select a wave form to be displayed for the wave form monitor. Y, Pb, Pr (HD signal)
Y, Cb, Cr (SD signal)
R, G, B (RGB signal)
WAVE FILTER
Turn on/off the lowpass filter to put over the input wave form data. FLAT (No filter)
LOWPASS
WAVE OVER LEVEL
*3
Set the over levels of the luminance signals (Y) and RGB signals.
Example of the wave form monitor
Ex.: When the luminance signal is Y, “MARKING” is set to “ON” and “LEVEL” is set to
“080”
Example of the vector scope
Ex.: When the color bar is
displayed
• The wave form color of signals over the value specified in “LEVEL” turns red.
• The display differs depending on the input signal or the “WAVE DISPLAY”
setting.
– MARKING
Turn on/off the function to change the wave form color of signals over the value
specified in “LEVEL.” (→ below)
OFF, ON
– LEVEL
Adjust the lower limit for the over level. 070 – 109
*1
The wave form monitor is not displayed when the input signals are DVI (input from a computer). The vector scope is not displayed when the
input signals are RGB.
*2
When “SIZE” is set to “LARGE,” the window is displayed in the center of the screen regardless of the “POSITION” setting.
*3
Not displayed in MIX mode or when the CAMERA ASSIST button is “ON.”
SYNC FUNCTION
Settings for the synchronization with signals.
Item Content Setting value
NO SYNC ACTION
Select the screen status when no signal is coming in. OFF
STANDBY
P.SAVE
GRAY B.
STANDBY
P.SAVE
GRAY B.
:
:
:
The monitor is off (on standby)
Power save mode
Gray screen
DELAY TIME
Select the period until the screen status changes as selected in “NO SYNC ACTION” after
signals stop coming in.
30sec., 5min., 15min.
LOW LATENCY
Activates/deactivates the function to shorten the time taken to display the picture.
• If the picture is not displayed steadily while “ON” is selected, select “OFF.”
• While “ON” is selected, the displayed picture may become unstable when an
operation using buttons on the front panel or the menu is performed, or when the
signal format changes.
ON
OFF
● When setting “NO SYNC ACTION” to “GRAY B.,” the screen color changes to gray and the power consumption of the back light is saved by
half. Selecting “P.SAVE” (power save mode) saves more power consumption by turning off the back light.
● In the initial setting, “NO SYNC ACTION” is set to “P.SAVE”, and “DELAY TIME” set to “15min.” Change the settings if necessary. (U.S.A. only)
Start End
Red
White
Y
Image signals