Filter
Top Products
40
ENGLISH
Symptoms Remedies/Causes
SD card/USB memory playback
• Noise is generated. The track played back is not an MP3/WMA track. Skip to
another file. (Do not add the extension code <.mp3> or
<.wma> to non-MP3 or WMA tracks.)
• “File Check” keeps flashing on the display. • Readout time varies depending on the device.
• Do not use too many hierarchy and folders.
• Turn off the power then on again.
• “No Files” appears on the display. Play a device that contains tracks encoded in an
appropriate format.
• “Not Support” appears on the display and
track skips.
The track is unplayable.
• “Read Failed” appears on the display, then
returns to the previous source.
• The device may be malfunctioning, or may not have
been formatted correctly.
The files included in the device are corrupted.
• Do not pull out or attach the USB memory repeatedly
while “File Check” appears on the display.
• “SD Loading Error” appears on the display
while playing tracks from an SD card.
Detach the control panel and reinsert the SD card. The
control panel goes back to initial position (Angle 1).
• While playing a track, sound is sometimes
interrupted.
MP3/WMA tracks have not been properly copied into the
device.
Copy MP3/WMA tracks again into the device, and try
again.
• Correct characters are not displayed (e.g.
album name).
This unit can only display letters (capital: A – Z, small:
a – z), numbers, and a limited number of symbols and
special characters (see page 26).
CD changer
• “No Disc” appears on the display.
Insert a disc into the magazine.
• “No Magazine” appears on the display. Insert the magazine.
• “Reset 8” appears on the display. Connect this unit and the CD changer correctly and press
the reset button of the CD changer.
• “Reset 1” – “Reset 7” appears on the display. Press the reset button of the CD changer.
• The CD changer does not work at all. Reset the unit (see page 2).
Sounds
• DSP mode cannot be selected other modes
than “Defeat.”
• Only high range sound or low range sound is
reproduced though full range speakers are
connected.
Deactivate crossover network (see page 21).
EN36-43_SH1000E_003A_3.indd 40EN36-43_SH1000E_003A_3.indd 40 1/3/06 9:30:11 AM1/3/06 9:30:11 AM