Filter
Top Products
132 Part8:TheMicrophone
Removing any low-frequency pop and rumble (MIC1)
On MIC 1, you can activate a low-cut lter to allow for a cleaner signal from
the microphone, by “cutting out” pops, oor rumble and mic handling noise.
1. Press the MIXER button to access the Mixer Menu.
2. Touch the VOICE P. Setup to access the Voice Processor Setup section.
3. Touch the SETUP button to go to the Setup page.
4. Touch the Low Cut pop-up menu, and choose one of the available lters.
5. Touch the SAVE command to save the settings to a Voice Processor Setup
(more info below).
6. Press the EXIT button to return to the main screen.
Automatically levelling dynamics through compression (MIC1)
On MIC 1, compression can even-out the dynamic level of your voice.
1. Press the MIXER button to access the Mixer Menu.
2. Touch the VOICE P. Setup to access the Voice Processor Setup section.