Filter
Top Products
Deviceutilities 199
4. Touch the USB Connection command to make the USB Connection dialog
box appear. (You can exit from this dialog box at any time, by pressing the
EXIT button).
5. Touch the ENABLE button to enable a USB connection with your PC.
The HD LED will start blinking, while the personal computer reads the
internal memory of the MP-10 PRO. This may take several minutes, de-
pending on the amount of data. Upon completion, the icon representing
the MP-10 PRO memory will appear alongside the other storage devices
connected to the computer:
Windows Mac
6. Once you are done transferring all data (the HD LED should have stopped
blinking), touch the DISABLE command to disconnect the USB le trans-
fer.
Note that the USB connection is also automatically disconnected when
disconnecting the USB communication from the personal computer. To
disconnect the USB communication on a Windows PC, you usually select
the dedicated command by clicking on the USB device icon in the Taskbar
with the left or the right mouse button. On the Mac, you must select the
USB device icon, then select the Eject command or drag it to the eject icon
in the Dock.
We suggest you to disconnect the USB connection from the personal com-
puter.
Warning: Do not disconnect USB communication before the personal computer
has nished transferring les. Sometimes, the on-screen indicator shows that the
procedure has been completed, BEFORE it is actually nished. Disconnecting
USB communication (or disconnecting the USB cable) before data transfer has
been completed may cause loss of data.