Filter
Top Products
148 Part8:TheMicrophone
sync signal will come from MIDI. When the MIDI source is selected, you
can set the beat unit with the R (Ratio) pop-up menu.
7. Use the High Frequency Damp pop-up menu to activate a low-pass lter
for the repetitions.
8. Touch the SAVE command to save the settings to a Voice Processor Preset
(more info below).
9. Press the EXIT button to return to the main screen.
Adding reverb to the microphones (MIC1/2)
On both MIC 1 and MIC 2, you can add ambient reverb. The reverb is the same
for both microphones, but you can set the level on each microphone separately.
You can turn this effect on/off quickly, by using the FX button on the control
panel.
1. Press the MIXER button to access the Mixer Menu.
2. Touch the VOICE P. Preset to access the Voice Processor Preset section.
3. Touch the FX button to go to the FX page.